“Load and save” panel

The “Load and save” panel (Fig. 10) allows to manage project files of the FullWaver survey.

Load and save panel.

Fig. 10 Load and save panel.

Load project

Loads a previously saved FullWaver project and redraws graphs to display the project properties.

The behavior of this command is different depending on the number and type of files that are being loaded. In general, a complete ERTdesign project consists of 3 files with the same name and with extensions .KML, .DATA and .TXT.

  • In the presence of all three files, the application uses the KML file to determine the position of receiving and transmitting electrodes and to load the polygon or polyline with survey area. The DATA file is used exclusively for reloading the combination of the transmitting dipoles (if consistent with the information on TX and RX, otherwise the dipoles are recalculated). The TXT file reloads the design settings used to generate the project.
  • When the DATA file is missing or when the DATA file does not contain information consistent with the KML file (different sensor names or missing sensors or other) the application uses the KML file to determine the position of receiving and transmitting electrodes and recalculates the combination of transmitting dipoles.
  • When the KML file is missing the application uses the DATA file to both derive the position of receiving and transmitting electrodes (which in this case will not be referenced in latitude and longitude) and to load the transmitting dipoles.
  • In the presence of the TXT file only, the program uses the file to reload the design settings stored in the file.

Save project

Saves the three files with project information:

  • the KML file with the position of the sensors (V-FullWaver box, receiving and transmitting electrodes, survey area). You can open this file in Google Earth TM , edit it and import it again into ERTdesign using the command Load project to check how signals and sensitivities change with the new geometry of electrodes.
  • the DATA file is a text file that contains the complete list of electrodes and quadrupoles. The file can be used to perform modeling tasks within the ERTLab64 TM and ViewLab3D softwares.
  • The TXT file contains the complete configuration used to generate the project. This file can be used for reloading the design settings.

Note

In case the area is not referenced, when saving the project, only the DATA file will be generated with the complete list of electrodes and quadrupoles. Of course, it is not possible to produce the KML file with the export of the sensors to be displayed on Google Earth TM .

Save spreadsheet TX

Allows to save the list with the sequence of the transmitting dipoles in a spreadsheet file (editable HTML format), to be used on site to keep track of injections and control every single step of the survey.

Check the include TX/RX map box to include in the document the figure with the sensors position map.